Bayside CALYPSO Instructions D'installation page 11

Calypso Installation Instructions
rod are secure.
BALANCING KIT: A balancing kit is provided to balance the ceiling fan on initial installation. Please refer
to the instruction on how to use the balancing kit. The balancing kit can be used to assist re-balancing
should the ceiling fan become un-balanced again. Store your balancing kit away after installation for
future use if required.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and
frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in
fan motor noise. This is normal. Please allow a 24-hour "breaking-in" period, most noises associated with
a new fan disappear during this time. Please note that this is not a product fault and as such is not covered
under warranty – All electric motors are audible to some extent.
CARE AND CLEANING:

Periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free
cloth to avoid scratching the paint finish. Please turn off electricity power when you do so.

Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create
the possibility of an electrical shock.

The motor has a permanently lubricated ball bearing so there is no need to oil.
NOTE: Always turn OFF the power at the mains switch before attempting to clean your fan.
Ceiling Fan model
48 inch blade fan only
48 inch blade fan with light
IN AUSTRALIA / NEW ZEALAND – Please refer to the separated WARRANTY STATEMENT.
IN EUROPE – If you are a European customer please contact the retail outlet where the fan was
purchased for warranty service.
11 | P a g e
All manuals and user guides at all-guides.com
TECHNICAL INFORMATION
Rated Voltage Rated Power (motor)
220-240 VAC
220-240 VAC
WARRANTY INFORMATION
Rated Power (lamp)
45W N/A
45W Max. 9W, GX53