Sinbo SHD 7019 Mode D'emploi page 7

ENGLISH
SINBO SHD 7019 CERAMIC HAIR STRAIGHTENER
INSTRUCTION MANUAL
SAFETY INSTRUCTIONS AND WARNINGS
• Read these ingstructions carefully before putting the appliance into operation and keep
them in a safe place for future consultation.
• This appliance is only for domestic use, not industrial use.
• Do not leave the appliance connected and unattended when not in use. Moreover, this
will allow saving energy and extending the life of the appliance.
• Do not leave the appliance within the reach of children or disabled individuals.
• Before connecting the appliance to the mains, check that the voltage indicated on the
nameplate coincides with the mains voltage.
• Do not use the appliance near the shower, bath or other containers holding water.
• Keep the appliance out of the reach of children.
• Before picking up the appliance after falling into water disconnect it immediately.
• Do not use the appliance on wet hair.
• Do not use the appliance if the cable or plug are damaged, or if not functioning correctly.
• Do not throw or insert anything into any of the appliance's cavities.
• Do not leave the appliance switched on top of any surface.
• Do not use the appliance where aerosols are in use.
• Do not position the hot parts of the appliance on heat-sensitive surfaces.
• The appliance heats when in operation. Do not bring the hot parts into contact with the
skin to avoid burns.
• Never leave the appliance connected to the socket.
• Never put the appliance away when it is still hot or connented.
• No liability is accepted for damage caused through inappropriate handling or use other
than that stipulated in this manual.
• Never wrap the cable around the appliance when it is still hot.
INSTRUCTIONS FOR USE
• Connect the appliance to a socket.
• Operate the start/stop switch
• The hair straightener has a built-in ceramic PTC system to keep the temperature of
the ceramic plates constant.
• In order to straighten hair perfectly, take a strand which is not too thick.
• Starting at the root, place it between the plates in a perpendicular position and gently
pull downwards until reaching the ends of the strand.
If necessary, repeat this action various times.
• Apply the same technique to the rest of the hair.
• When finished, disconnect the appliance by putting the switch in the stop position and
unplug it from the socket.
- 6 -