QuickCable iStart Mode D'emploi page 3

Using the iStart
Before using your portable power pack, you should fully charge it. The high
charge indicator light will come on when the unit has been charged. Re-
charge every 30 days or when the medium or low lights indicate less than full
charge. Fluctuations in temperature can accelerate battery discharge. Check
your unit often.
WARNING – Risk of Battery Explosion, Fire or Failure
• Failure to keep internal battery charged will lead to permanent battery damage.
• Connecting a discharged battery to charged system could cause overheating or explosion.
To jump start a vehicle or machine:
• Make sure the iStart
• Connect the red (positive +) clamp to the positive terminal or post on the
discharged battery.
• Connect the black (negative –) clamp to a ground away from the battery,
such as an alternator bracket.
• If connections are reversed, polarity alarm will sound and reversed
connections light will be red.
• Turn the power switch ON.
• Start the engine.
• Turn the power switch OFF.
• Disconnect the clamps, first negative and then positive.
All manuals and user guides at all-guides.com
™
power switch is OFF.
™
3