Champlain ACM-125 Installation

ACM-125 / ACM-125C
Universal Pool Light
INSTALLATION ON A POOL STEP
1) Assemble step as per instructions.
KEEP STEPS AND LIGHT DRY DURING INSTALLATION.
2) Using a 2" (50.8mm) cutting devise, drill a hole in the second riser
from the top at 4-1/2" (114.3mm) from the top at center.
3) Thread the electrical cord through the hole (as per drawing).
4) Secure the light from behind with the plastic nut.
DO NOT OVERTIGHTEN.
5) Secure plastic nut with the safety cap and 2 supplied screws.
6) Attach the electrical cord to the step.
7) Make sure the transformer is out of the water. Slide plastic
O-ring onto transformer plug.
8) Insert pins into transformer outlet and secure with cap.
9) The transformer should be plugged into a GFCI outlet.
»
¶
Champlain Plastics Inc.
87 Pillsbury Road, Rouses Point, NY 12979
(INS-ACM125-rev2)
All manuals and user guides at all-guides.com
²
• Risk of electrical shock, if instructions are not followed. Connect only to a
grounded GFCI outlet that is a minimum of 10 feet (3 m) away from the
pool. DO NOT USE EXTENSION CORDS.
• Make sure the electrical cord is properly attached to the step to avoid
entanglement.
• Do not let children use this device unsupervised.
• For use on permanent above-ground pools only.
• Do not use the light if the lens, transformer or cord is damaged.
WINTER STORAGE: Freezing weather may damage light fixture.
Disconnect light and remove from the pool. Store in dry space at room
temperature.
·
4-1/2"
from top
of riser
and centered
on riser
¿
WARNING
´