Texas A/S TG385 Manuel De L'utilisateur page 12

8. Operation
1. Hold the handle/ engine brake lever on which the engine is mounted activated.
Please draw attention to the following during operation.
-
The exhaust must not be black. If this occurs the load is too high or the engine has
-
not been adjusted correctly.
- No incorrect noises and vibrations.
- If any of the above appears, turn off the engine and adjust it or contact your Power
Line dealer.
9. Spark plug
Remove the sparking plug cover. (Caution, it may be hot, if the engine have been
-
running).
Brush off dirt from the spark plug.
-
Use a spark plug wrench to loosen the spark plug.
-
Inspect if the isolation is intact.
-
Clean the spark plug with a steel brush.
-
- Measure the electrode distance; make sure not to damage the electrode.
The distance should be: 0.7 – 0.8 mm.
-
- If the sparking plug is okay, put it back in its place.
- Otherwise replace using Tex-Part 10011440
- Put the sparking plug cover back in its place.
See fig 1, pos 1.
All manuals and user guides at all-guides.com
OPERATION
NOTE
PROCEDURE
12