Publicité
Les langues disponibles
Les langues disponibles
Extracting transmission fluid through the dipstick tube
1.
Operate the vehicle to warm the transmission fluid to a normal operating temperature.
Caution: Do not attempt to extract fluids at temperatures greater than 175° Fahrenheit
(80° Celsius).
2.
Properly park the vehicle on level ground and turn the engine off.
3.
Remove the transmission fluid dipstick.
4.
Insert the appropriate diameter dipstick tube into the dipstick fill hole until it reaches the bottom of the
transmission pan.
5.
Connect the main suction tube to the dipstick tube.
6.
Insert the rubber plug of the main suction tube into the reservoir adapter, and then insert the adapter into
the pour spout on the top of the reservoir. Ensure the tube connections are tight to prevent leakage.
7.
Extract the used transmission fluid by pumping the evacuator handle several times to create a vacuum.
Once the fluid begins to flow into the reservoir, continue to operate the pump until all the fluid has been
drained from the transmission pan.
8.
Remove the reservoir adapter from the reservoir, pour the used transmission fluid from the reservoir into
a suitable container, then dispose of the fluid in an appropriate manner.
9.
Rinse the evacuator reservoir, pump, adapter, and tubes with clean solvent or engine degreaser, and al-
low them to dry thoroughly.
10. Refill the transmission with new fluid in accordance with a proper vehicle maintenance guide.
In some applications, this may require jacking or lifting the vehicle. Use appropriate safety stands
to avoid serious or fatal injury.
Extracting oil from a differential
1.
Operate the vehicle to warm the differential to a normal operating temperature. Caution: Do not attempt
to extract fluids at temperatures greater than 175° Fahrenheit (80° Celsius).
2.
Properly park the vehicle on level ground and turn the engine off. If required, properly lift and support the
vehicle to allow access to the differential fill plug located on the differential housing or cover.
3.
Remove the differential fill plug.
4.
Insert the appropriate diameter dipstick tube into the fill hole until it reaches the bottom of the differential
housing.
5.
Connect the main suction tube to the dipstick tube.
6.
Insert the rubber plug of the main suction tube into the reservoir adapter, and then insert the adapter into
the pour spout on the top of the reservoir. Ensure the tube connections are tight to prevent leakage.
7.
Extract the used oil from the differential by pumping the evacuator handle several times to create a vacuum.
Once the fluid begins to flow into the reservoir, continue to operate the pump until all the fluid has been
drained from the differential.
8.
Remove the reservoir adapter from the reservoir, pour the used differential oil from the reservoir into a suit-
able container, then dispose of the oil in an appropriate manner.
9.
Rinse the evacuator reservoir, pump, adapter, and tubes with clean solvent or engine degreaser, and allow
them to dry thoroughly.
10. Refill the differential with new oil in accordance with a proper vehicle maintenance guide.
Never remove the cap from the radiator or expansion tank while the engine is at operating temperature. Al-
ways allow the engine to cool before removing the radiator cap or expansion tank cap. The cooling system
is under pressure. Failure to allow the engine to cool before attempting to remove the cap could result in
injuries.
serious
Extracting coolant from a radiator or expansion tank
1.
Properly park the vehicle on level ground and turn the engine off.
2.
Allow engine to cool completely. Caution: Do not attempt to extract fluids at temperatures greater than 175°
Fahrenheit (80° Celsius).
3.
Remove the radiator or expansion tank cap.
Page Number - 4
All manuals and user guides at all-guides.com
Form 824556
Publicité
