Télécharger Imprimer la page

Westfalia 34 07 45 Mode D'emploi page 9

Publicité

Please note the included General Safety Notes and the following
safety notes to avoid malfunctions, damage or physical injury:
Persons with limited physical, sensorial or mental abilities are not allowed
to use the unit, unless they are supervised and briefed for their safety by a
qualified person.
Make sure, the operating voltage stated on the type label corresponds to
the power mains available in your area.
Before each use please check the power cable for any damages. If there
are any damaged spots have the power cable replaced by a professional.
Before starting any work on walls, floors or similar, make sure that all
power lines in the work area are switched off at the main switchboard.
Inspect the proposed drill hole location for any utility lines (e. g. water, gas,
power) before drilling. Use a suitable device such as a metal or electricity
line detecting device.
Make sure the cord cannot get caught in any way.
Do not jam the cord or wind the cord around the unit and do not bend it.
Do not pull the cord around edges. Do not pinch the power cord in any
way and keep it away from hot surfaces.
Make sure that the ventilation louvers are clean and free from
obstructions.
Please switch OFF the unit and unplug from the power supply before
cleaning, maintaining or when not in use.
Use the auxiliary handle delivered with the unit. Loss of control of the
pneumatic impact drill can cause injuries.
Always wear ear protection when working with the
pneumatic impact drill. The noise can head to ear
damage. Wear a dust mask to protect yourself from
potentially hazardous dust. When chiselling, preferably wear safety
goggles to protect your eyes against thrown particles.
The drill hammer has a hand arm vibration of 23.49 m/s
due to the hand arm vibration, take sufficient rest breaks.
Before undertaking any work on the machine, pull out the power plug to
avoid unintentional start-up.
Please notice: Only Change the operating mode (drilling/impact
drilling/chiselling) when the machine is at a complete standstill.
If the machine was dropped and becomes damaged, immediately switch
off the unit and do not use it further. Do not disassemble the unit and do
not try to repair it yourself. Contact our customer service.
All manuals and user guides at all-guides.com
Safety Notes
4
2
. To avoid injuries

Publicité

loading