Publicité
Les langues disponibles
Les langues disponibles
Step 1
Thread Net on PVC Hoop.
1
This is the net right out of the package.
You will be working with the longer looped end.
2
This is a close-up of diagram 1. This is one loop.
3
Fold the loop toward you, creating two loops.
4
Insert your nger through the two loops.
5
Release the thumb holding the loop in place and pull
on the two middle strings. The loop should slide up
and catch your ngers.
Take the loop from your nger and slide onto the
6
basketball hoop. Continue this process with each
loop until all loops are on the hoop.
Backboard
Hoop
Bracket
Step 3
• Fill Base with water or sand (preferred) and cover
up opening with Base Cap.
Step 4
• Insert the PVC Backboard Support into the Base
AT AN ANGLE. (Diagram A) While pushing Support into the
base, keep it pulled back a bit to make sure that the Support
CLEARS the insert that is built into the base at the opening
(Diagram B). Use a Rubber Mallet if necessary.
• Once the Support is inserted into the base, secure through the
4th hole from the top with (1) 2½" bolt. (Diagram C)
DIAGRAM C
4th Hole
Bottom
½"
2
hole with
Insert
Bolt
Note:
Step 2
• Attach the Hoop to the Backboard by inserting (2) 2½"
Bolts through the Hoop Bracket, Hoop and Backboard as
pictured and secure with Washers and Hex Nuts.
½"
2
Bolt (2)
Step 5
• Attach the PVC Backboard Support to the
Backboard using (1) 4 ½'' bolt through the
bottom hole of the Backboard Hoop Bracket
and into the 2nd hole from the top of the PVC
Backboard Support. Secure with washer and
hex nut.
• Secure backboard with 3" bolt to the bottom
hole insert of the Backboard Support.
Step 6
• Use Ball Needle and a hand pump (not
included) to in ate.
1
2
4
5
Visit poolmaster.com, search 72781 for net video instructions.
DIAGRAM A
Base Cap
3
6
DIAGRAM B
Insert
2nd Hole
½"
4
Bolt
"
3
Bolt
poolmaster.com
2
Publicité
