Publicité
Vacuum Cleaning
Note: Do not use the appliance until the collecting tray (1) and both filter (2
and 3) have been inserted correctly.
While vacuum cleaning ensure that the air outlet port at the motor unit are
unobstructed.
1. Slide the ON switch (6) forward and hold it in this position in order to
switch on the vacuum cleaner.
2. Release the switch to switch off the vacuum cleaner.
If the vacuum cleaner stops working, hang the vacuum cleaner on the
charging station and have the battery recharged.
Wet Vacuum Cleaning
1. When wet vacuum cleaning hold the appliance vertically with the
suction opening facing down. Do not exceed the max. marking (80 ml).
Note: Empty the liquids immediately after sucking up!
2. After wet vacuum cleaning keep the appliance vertical down until you
have emptied the collecting tray (1). If you want to dry vacuum clean
after you have wet vacuum cleaned, thoroughly dry the collecting tray.
Cleaning
▪ Disconnect the collecting tray (1) from the motor unit by pressing the
release button (4). The collecting tray will tilt downwards.
▪ Remove the fabric filter (3) and the mesh filter (2) from the collecting
tray and empty the collecting tray (1).
▪ A damp cloth can be used to clean the inside of the collecting tray.
▪ To clean the filters more thoroughly, rinse them with cold tepid water.
Dry the filters completely before you replace them into the collecting
tray! If necessary, use a brush with soft bristles to clean the filters from
dust and dirt.
▪ Check if the filters are correctly inserted into the collecting tray. The
filters only fit in one position into the collecting tray. Maximum dust
collection will only be obtained with clean filters and empty collecting
tray.
All manuals and user guides at all-guides.com
Operation
13
Publicité
