Under Control 2925 Notice D'utilisation page 7

3. 6Axis adjustment
For first time use, 6Axis adjustment is suggested to be to ensure the Axis can work normally.
A. Choose the calibrate motion controls in system settings. Turn off the game controller,
hold "-", "B" and then "Home" button for about 3-5 seconds to enter axis adjustment mode,
LED1 + LED2 and LED3 + LED4 blink alternately.
B. Put gamepad on a plat position, hold "+" button, console will adjust automatically, after
adjustment, gamepad should connect to console, LED keeps light to show player.
C. After adjustment finished, please enter to the adjustment system to check again whether
the adjustment was success.
D. Console will check automatically, when the window as shown below appeared, means
the adjustment finished successful, the controller can be used normally.
A
C
Sleep mode
1. When connected, the console screen power off, the controller goes to sleep mode.
2. When connected, the controller without any action in 5 minutes then step into sleep mode.
Reconnect mode
Based on the console not in sleep mode, if the controller under sleep mode, press "Home"
button for 1 second to wake up the controller, and it will searched and reconnect for the
already connected console. If cannot reconnect in 10 seconds the controller will step to
sleep mode. No other function buttons can wake up the controller.
Charging
When power off the controller,the LED1-4 flashes slow. After full charge, LEDS should turn
off. When the controller is connected, under charging, the current connected LED indicator
flashes slow, and after full charge, the LED indicator will keep light. When the controller
low power,the LED indicators flashes fast to remind.
EN
B
D