Husqvarna G483ST Manuel Du Propriétaire page 6

DRAWBAR B (SEE FIG. 1D)
1. Discard adapters provided - not required for drawbar
type B.
2. Align support assembly pin with hole in drawbar and
hang assembly over the shoulder bolts.
3. Be sure support assembly is seated properly and secure
with retainer spring supplied.
SUPPORT
ASSEMBLY
PIN
RETAINER
SPRING
DRAWBAR D (See Figs. 1E)
1. Slide flanges of support assembly into drawbar slots first,
then, pivot backwards inserting pin into drawbar pin hole.
2. Be sure support assembly is seated properly, then secure
with retainer spring.
INSERT
FLANGES
FIRST INTO
DRAWBAR
SLOTS
DRAWBAR
PIN HOLE
SHOULDER
BOLTS
3064
FIG. 1D
SUPPORT
ASSEMBLY
DRAWBAR SLOTS
(Drawbar "A" shown)
RETAINER
FIG. 1E
SPRING
2
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY (See Fig. 2)
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person for mounting cover assembly
to tractor.
1. Position cover assembly on ground behind tractor.
2. Lift and rotate cover to align cover brackets with support
assembly tubes.
3. Slide cover assembly down onto the support tubes.
COVER
ASSEMBLY
PIN
6
SUPPORT
ASSEMBLY
03024
FIG. 2