Publicité
Les langues disponibles
Les langues disponibles
Assemble the main box by gluing the side panels (1), the back panel (2) and the front panel
(3) together using UHU wood glue, holding the parts together using screw-clamps or strips of
adhesive tape stretched round the corners. Take care to keep all joints at right-angles -
measure the diagonals to check this. Allow the glue to set hard, then attach the bottom panel
(4) using UHU wood glue and the panel pins (15).
Assemble the drawer by gluing the side panels (5), back panel (6) and front panel (7)
together, using clamps or tape as described previously. Take care to keep all joints at right-
angles - measure the diagonals to check. Allow the glue to set hard, then attach the drawer
bottom (8) using wood glue and the panel pins (15).
Glue the drawer guides (9) to the inside of the side panels (1) (left and right) in the starter
box, resting on the bottom panel (4). Glue the battery compartment floor (10) to the drawer
guides (9). Lay the side panel (11) of the battery compartment on the floor of the battery
compartment (10), and glue it to the side panels (1).
Fit the handle (14) through the holes in the side panels, and glue it in place with the ends
flush.
Glue the partition (12) centrally to the second battery compartment floor (10).
Glue the parts of the power panel box (16) together as shown in the separate sketch.
Glue the power panel box to the battery floor and the partition. Cut the triangular fillet (13) to
length and glue it to the partition and the floor panel as shown. Drill a hole in the floor panel
(10) for the cables, in the corner of the power panel box.
Glue the plywood feet (17) to the bottom of the starter box (4) to provide a more
stable base for the pit-box.
Parts List
Part
Description
No.
1
Pit-box side panel
2
Pit-box back panel
3
Pit-box front panel
4
Pit-box bottom panel
5
Drawer side panel
6
Drawer back panel
7
Drawer front panel
8
Drawer bottom panel
9
Drawer guide
10
Batt. compartment floor
11
Batt. compartment side
12
Partition
13
Triangular fillet
14
Handle
15
Panel pin
16
Power panel box
17
Foot
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler!
All manuals and user guides at all-guides.com
Building Instructions
No. off
2
1
1
1
2
1
1
1
2
2
2
1
2
1
32
1
4
3
Material
Plywood
Plywood
Plywood
Plywood
Plywood
Plywood
Plywood
Plywood
Plywood
Plywood
Plywood
Plywood
Balsa
Beech
Metal
Plywood
Plywood
Ident. # 0059327 2008
Order No. 1691
Dimensions in mm
250 x 230 x 8
360 x 145 x 8
360 x 81 x 8
370 x 230 x 3
221 x 60 x 8
326 x 60 x 8
326 x 60 x 8
221 x 336 x 3
221 x 64 x 8
353 x 213 x 3
212 x 40 x 8
353 x 45 x 8
370 x 15 x 15
371 x Ø 30
5
20 x 20 x 8
Publicité
