Publicité
asa# sh run dhcpd
dhcpd auto_config outside **auto-config from interface 'outside' **auto_config dns x.x.x.x
x.x.x.x <-- these lines will depend on your ISP **auto_config domain isp.domain.com <-- these
lines will depend on your ISP ! dhcpd address 10.0.0.2-10.0.0.100 inside dhcpd dns 10.0.0.250
interface inside dhcpd enable inside ! dhcpd address 10.1.0.2-10.1.0.100 wifi dhcpd dns
10.0.0.250 interface wifi dhcpd enable wifi ! asa#
HTTP :
asa# show run http
http server enable
http 0.0.0.0 0.0.0.0 outside
http 0.0.0.0 0.0.0.0 inside
asa#
Configuration WAP Aironet (sans l'exemple de configuration SSID)
asa# session wlan console
ap>enable
Password: Cisco
ap#configure terminal
Enter configuration commands, one per line.
ap#show configuration | include default-gateway
ip default-gateway 10.1.0.1
ap#show configuration | include ip route
ip route 0.0.0.0 0.0.0.0 10.1.0.1
ap#show configuration | i interface BVI|ip address 10
interface BVI1 ip address
10.1.0.254 255.255.255.0
Configuration du module FirePOWER (avec commutateur interne)
asa# session sfr console
Opening console session with module sfr.
Connected to module sfr. Escape character sequence is 'CTRL-^X'.
> show network
===============[ System Information ]===============
Hostname
Domains
: Cisco_SFR
: example.net
End with CNTL/Z.
Publicité
