Impulsion HA01 Manuel D'instruction page 6

To clean the transducer:
1) Pour 2 to 5 drops of vinegar on its surface and leave for 2 to 5 minutes.
2) Brush the scale off the surface with a soft brush. Do not use a hard tool to scratch at the surface.
3) Rinse the tank with fresh water.
4) Do not use soap, solvent or any other cleaning spray to clean the transducer.
To clean the tank unit:
1) Clean the water basin using a soft cloth and vinegar if there is any residue or calcium deposit inside.
2) Rinse the tank with clear water.
Storage:
Store the device in a dry cool place, out of reach of children after it has been cleaned and dried.
TROUBLESHOOTING
EN
If the appliance malfunctions in everyday use, please refer to the table below:
BREAKDOWN
No vapour, no indicator light
The vapour has an unusual smell
Low intensity
ADVICE REGARDING THE DISPOSAL OF WASTE
• All the packaging is composed of materials that pose no hazard for the environment and which can be disposed of at
your local sorting centre to be used as secondary raw materials. The cardboard may be disposed of in a paper recycling
bin. The packaging film must be taken to your local sorting and recycling centre.
• When you have finished using the device, please dispose of it in an environmentally friendly way and in accordance with
the law.
aroma humidifier
6
POSSIBLE CAUSES
If no light I being emitted.
The water level in the tank is too low. Add water to the tank.
The cable passes above the transducer. Reposition it correctly.
The water tank is leaking.
The temperature of the device is too
low.
The water has been in the tank too
long.
Too much/little water in the tank.
Sediment on the transducer.
The water is too cold.
The water is unclean.
REMEDIES
Check that the device is plugged in
and that there is not a problem with
the mains supply.
Check that the rubber stopper is
positioned correctly.
Place the device in the room at room
temperature for half an hour prior
to use.
Clean the tank and fill with fresh
water.
Empty/fill the water tank.
Clean the transducer.
Use water at room temperature.
Clean the tank and fill with fresh
water.