EAS ELECTRIC M-THERMAL Manuel D'instruction page 50

6.10 Network Configuration Guidelines
The wired controller realizes intelligent control with a built-in
module, which receives control signal from the APP.
Before connecting the WLAN, please check for it if the router in
your environment is active and make sure that the wired
controller is well-connected to the wireless signal.
During the Wireless distribution process, the LCD icon "
flashes to indicate that the network is being deployed. After the
process is completed, the icon "
6.10.1 Wired Controller Setting
The wired controller settings include AP MODE and RESTORE
WLAN SETTING.
WLAN SETTING
AP MODE
RESTORE WLAN SETTING
ENTER
OK
Activate the WLAN by interface. Go to "MENU"> "WLAN
SETTING"> "AP MODE".
Press"OK", the following page will appear:
AP MODE
Do you want to activate the
WLAN network and exit?
NO
CONFIRM
OK
Use ''◄''， ''►'' to move to"YES", press "OK" to select AP mode.
Select AP Mode correspondingly on the mobile device and
continue the follow-up settings according to the APP prompts.
CAUTION
After enter Ap mode, if it's not connected with mobile
phone, the LCD icon " " will flash 10 minutes then
disappear.
If it's connected with the mobile phone, the icon "
will be constantly display.
Restore WLAN setting by interface. Go to "MENU"> "WLAN
SETTING" > "RESTORE WLAN SETTING" .
Press"OK", the following page will appear:
"
" will be constantly on.
YES
"
RESTORE WLAN SETTING
Do you want to restore the
WLAN setting and exit?
NO
CONFIRM
OK
Use ''◄''， ''►'' to move to "YES", press "OK" to restore
WLAN setting.Complete the above operation and wireless
configuration is reset.
6.11 SN VIEW
SN VIEW
HMI NO.
***********************************************
SN VIEW
IDU NO.
********************************
ODU NO.
********************************
21
YES
#1
V.2