Emptying The Water Tank; Continuous Drainage - SOLIS Easy dry compact 708 Mode D'emploi

EMPTYING THE WATER TANK

When the water tank is full, the unit will switch off
automatically and beep 15 times, the LED [1] of
water tank full on the control panel will light up.
The tank needs to be emptied:
• Lightly press on the sides of the tank with both
hands and pull out gently.
• After discarding the water, gently push the tank
back into its place. The LED light will go off.
Warning:
1. Do not remove the float from the water tank,
the water tank full sensor will no longer be able
to detect the water level correctly without the
float and water may leak from the water tank.
2. If the tank is dirty, wash it with cold or lukewarm
water. Do not use detergent, scouring pads, che-
mically treated dust cloths, gasoline, benzene,
thinner or other solvents, as these can scratch
and damage the tank and cause water leakage.
3. When replacing the water tank, press the tank
firmly into place with both hands. If the tank
is not positioned properly, the water tank full
sensor will be activated and the dehumidifier
will not operate.

CONTINUOUS DRAINAGE

For the continuous drainage please refer to the
following instructions and the picture.
1. Switch off the unit and remove the plug from
the electrical outlet.
2. Create an opening (remove part A) for the
drainage tube on the tank.
E
3. Push a drain tube (14 mm outer diameter,
10 mm inner diameter) through the hole and
connect to the continuous drainage port
(part B).
4. Place the other end in a drain. Make sure the
tube is free from twists and bends.
Note:
The water tank has to remain in place during
continuous drainage.
30
A
B