CEBEK FE-113 Guide Rapide

Power supply including transformer shorting on the same circuit.
Supports voltage adjustment between 10 and 15 V.D.C.
Incorporates input fuse and LED indicator.
INSTALLATION OF INPUT : 230VAC Power on the network., Use a plug and a cable and connect it to the input
terminal "INPUT". Install a switch and a fuse for protection and safety, as reflected in the CE standard.
Note that in different parts of the circuit circulate 230V.AC
INSTALLATION OUTPUT: Respecting the polarity of the output of the power, connect it to the device you want to
control. Remember that provides up to 270 mA. If you try to feed a higher consumption device will protect the source,
lowering the output voltage. Install the power preferably in a well ventilated box.
OPERATION AND ADJUSTMENT : After installation you could switch, activating the source. The LED indicates the
circuit operation enlightening. If you turn off the power or short circuit occurs, the LED will turn off.
Allows adjustment of the output voltage between 10 and 15V.DC, to select the desired value adjust the variable resistor
circuit, indicated as "ADJUST".
FUSE REPLACEMENT: If you must change the fuse, perform removing power from 230V. Remove fitting and replace
it with a 200 mA. Finally replace the protector.
CONSIDERATIONS: The power supply has short circuit protection, however the maximum time of 30 seconds
performances, so when this act should disconnect the device powered and cool the source for a period of not less than
1 minute .
SOURCE D'ALIMENTATION
FUENTE DE ALIMENTACION
www.cebek.com -
POWER SUPPLY
Font d'alimentació
12V DC / 270 mA
FE-113
TECHNICAL CHARACTERISTICS
Input Voltage : 230.V.AC
Output Voltage : 12V.DC. (10-15V.DC)
Maximum output constant current : (270 mA 12V.DC).
Maximum ripple load : 5mV
Response time to output short circuit Loaded : (0.3seg )
Vo.short recovery time. (Loaded ) : 1.5 sec.
Fuse : 200mA.
Sizes : 72 x 652 x 30mm.
Din Rail : C-7564
sat@fadisel.com