Transportation And Storage - Husqvarna DS 500 Manuel D'utilisation

To adjust the drill motor carriage
If there is distance between the drill column and the drill
motor carriage, the drill motor carriage must be
adjusted.
1. Loosen the screws that hold the roller shafts.
2. Adjust the roller shafts. Turn the screw
counterclockwise to move the guide wheels in the
direction of the drill column.

Transportation and storage

• Safely attach the product during transportation to
prevent damage and accidents.
• The accessory transport wheels can be used to
transport the stand with mounted drill unit.
922 - 002 - 06.03.2019
6 mm
Transportation and storage
3. Lock the position of the guide wheel with a wrench.
Tighten the screw to lock the roller shaft with a hex
key.
Note: After you have tightened the roller shafts, they
must be possible to turn with the feed lever but not
by hand.
4. Use the feed lever to move the motor carriage up
and down. Make sure that the drill motor carriage
moves smoothly on the drill column. The roller shafts
must rotate and not move. If it is necessary, adjust
the roller shafts again.
• Without transport wheels the drill unit needs to be
dismounted from the stand during transport as the
combined lifting weight is above 25 kg.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
11