Publicité
Les langues disponibles
Les langues disponibles
How to Do More
How to Set the Extender IDs
The RF Extender can be used in several situations as illustrated in the picture on
p. 4: out of sight, in an adjacent room, or inside a closet.
Since the RF Extender 'communicates' with the Marantz touch screen remote
control, you must set the same Extender ID (identity) on both appliances. The
settings depend on whether you have a single RF Extender or multiple RF Extenders.
Single RF Extender
When you use only one RF Extender, you can accept the default setting for the
Extender ID (ID=0).
On the Marantz touch screen remote control, choose the same Extender ID for
I
each device controlled by the RF Extender.
Refer to the User Guide of Marantz remote control for more information.
Multiple RF Extenders
If you want to operate several of your devices independently, e.g. grouped in
different locations, you need multiple RF Extenders. When using several
RF Extenders, it is important to assign a unique Extender ID to each Blaster unit.
You can assign 16 Extender IDs (from 0 to 9 and from A to F).
For the three RF Extenders in the picture on p. 4, you can set the Extender IDs as
described below:
For situation A, set the Extender ID to 0;
I
I
For situation B, set the Extender ID to 1;
I
For situation C, set the Extender ID to 2.
1 Choose an Extender ID for the Blaster unit by turning the ID dial with a
small screwdriver.
User Guide
12
Publicité
