Publicité
Disconnect spark plug wire before performing any maintenance (except car bu re tor adjustment) to
prevent accidental start ing of engine.
Prevent fires! Keep the engine free of grass, leaves, spilled oil, or fuel. Re move fuel from tank
before tipping unit for maintenance. Clean muffler area of all grass, dirt, and debris.
Do not touch hot muffler or cylinder fins as contact may cause burns.
ENGINE
LUBRICATION
Use only high quality detergent oil rated with API service
classification SG-SL. Select the oil's SAE vis cos i ty grade
according to your expected temperature.
SAE VISCOSITY GRADES
10W-30 / 5W-30
-20
0
30
F
C
-20
-30
-10
TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
NOTE: Although multi-viscosity oils (5W-30, 10W-30, etc.)
improve starting in cold weather, these multi-viscosity oils
will result in increased oil consumption when used above
40°F (4°C). Check your engine oil level more frequently to
avoid possible engine damage from running low on oil.
Change the oil after every 25 hours of operation or at
least once a year if the tiller is not used for 25 hours in
one year.
Check the crankcase oil level before starting the engine
and after each five (5) hours of continuous use. Add SAE
30 motor oil or equivalent. Tighten oil filler plug securely
each time you check the oil level.
TO CHANGE ENGINE OIL (See Figs. 19 and 20)
•
Be sure tiller is on level surface.
•
Oil will drain more freely when warm.
•
Use a funnel to prevent oil spill on tiller, and catch oil
in a suitable con tain er.
•
Remove drain plug.
•
For easier removal of plug use 7/16 12 Pt. socket with
extension.
•
Tip tiller forward to drain oil.
•
After oil has drained completely, replace oil drain plug
and tighten securely.
•
Remove oil filler plug. Be careful not to allow dirt to
enter the engine.
•
Refill engine with oil. See "CHECK ENGINE OIL LEVEL "
in the Operation section of this manual.
OIL
DRAIN
PLUG
MAINTENANCE
SAE 30
40
60
80
4
10
20
30
oil_visc_chart5_e(drt)
FIG. 19
OIL LEVEL
OIL FILLER
PLUG
FIG. 20
AIR FILTER (See Fig. 21)
Service air cleaner cartridge every twen ty-five hours,
more often if engine is used in very dusty conditions.
1. Loosen air cleaner screw.
2. Remove air cleaner cover.
3. Carefully remove air cleaner cartridge. Be care ful. Do
not allow dirt or de bris to fall into carburetor.
4. Clean by tapping gently on a flat sur face.
NOTE: If very dirty or damaged, replace car tridge.
5. Clean and re place cover. Tighten screw securely.
CAUTION: Petroleum sol vents, such as kerosene,
100
are not to be used to clean car tridge. They may cause
40
de te ri o ra tion of the cartridge. Do not oil car tridge. Do
not use pres sur ized air to clean or dry car tridge.
Cover
Air Cleaner
Screw
13
Air Clean er
Car tridge
FIG. 21
Publicité
