IB RUBINETTI BOLD 400 Notice De Montage page 3

EN
TECHNICAL DATA
Minimum dynamic pressure:_________________________________________________________0.5 bar
Maximum operational pressure:________________________________________________________5 bar
Recommended operational pressure:_________________________________________________1-5 bar
It's recommended to use a pressure reducer in case of
static pressure superior than 5 bar inside the waterpipe.
Maximum hot water temperature:_______________________________________________________80°C
INSTALLATION, MAINTENANCE AND PRELIMINARY CHECKING PROCEDURE
In order to get your device work correctly and fi ne in time, must ensure compliance with the
mode of installation and maintenance described in this booklet. Relying on a qualifi ed plumber.
Make sure that the system is free from all debris and impurities existing.
INSTALLATION
Fig. 1: Make a MIN 60 – 2.36 in, MAX 100 mm – 3.93 in hole into the wall.
N.B.: MIN and MAX measure are referred to the fi nished wall, cladding included.
Fig. 2: Insert the body into the hole previously done.
Fig. 3 - 4: Connect the body to the hydric system by following the arrow printed on it in order to
defi ne the entrance and the exit. It's recommended to use hemp or PTFE to assure the enduran-
ce. Fix the recessed body taking in consideration the vertical and horizontal perpendicularity.
Do it with the help of a spirit level.
After connecting the body to the system, turn on the stopcocks and check that the mixer tap
unit operates correctly. Keep the tap pressurised for a few minutes checking eventual leaks.
Fig. 5: Reduce the hole in the wall, leaving diameters Ø40mm - 1.57 in both for cold and hot
taps and for the diverter.
Fig. 6: Screw the fi nishing ring into the taps until it is completely blocked, insert the fi nishing
rosette. Fix the handle on the broach and lock it with the screw.
CLEANING
In order to obtain a correct cleanliness, exclusively wash them with soap and water, rewash and
dry them with a soft towel and deerskin. Avoid the usage of alcohol, solvents, solid or liquid
detergents which contain corrosive or acidic substances, abrasive sponges, swab with metallic
strings because they could irreversibly compromise the surfaces.
THE USAGE OF THIS KIND OF DETERGNETS DURING THE CLEANING OF THE MIXER EXCLUDE
IB RUBINETTERIE FROM ANY WARRANTY OBLIGATION.