Publicité
Les langues disponibles
Les langues disponibles
3.
REVERSE THE OPENING
3.1
Remove the door from its hinges
3.2
Remove the hinges and the
locking plates
3.3
Exchange the position of the
hinges and the locking plates
3.4
Attach the door to its hinges
again
CONSTRUCTION & RÉNOVATION
4.
WIRING INSTRUCTIONS
The following instructions are only applicable to
connections to be carried out by an installer. The
control panel wiring has already been carried out
in the factory and must not be modified under any
circumstances for risk of deterioration or accident.
The sensors must be connected to the control panel
in accordance with the diagram enclosed. The
respective power supply cables are protected by
protective conduits (see C-15-100 standard).
5.
HYDRAULIC CONNECTIONS
Connect the electric valve to the local water supply.
The union fittings to connect the electric valve
can be removed and a shut-off valve is used for
insulation at the top. The valve is for direct supply of
the balance tank, not of the swimming pool.
6.
SENSORS
The placement of the sensors in the balance tank
has an impact on the regulation performance. The
height of each sensor must be determined correctly.
Several days may be necessary to determine the final
levels depending on the depth of the balance tank and
compared to its volume.
7.
SENSOR FUNCTIONS
A - Mass sensor : This sensor must be placed
at the deepest possible point of the balance tank to
ensure permanent contact with water. This sensor
provides for the contact with the other sensors,
depending on the water level.
B and C - Low level safety sensors : If the
water level is below the B sensor, the control panel
will interrupt filtration pump operation. At the same
time, the filling electrovalve is open to fill the balance
tank with water.
When the water level has reached the C sensor,
the pump will continue to operate.
D and E: High level safety sensors : If the
water level rises above the E sensor, the control
panel will start the filter pump so that the water flows
back into the swimming pool (except the filtration
switch is in the «off» position). The pump will be
stopped, when the the water level is below the D
sensor again.
2022/07 - Indice de révision : C - Code : 32936
9/24
Publicité
