Input Connection - YORKVILLE TWO Série Manuel De L'utilisateur

Masquer les pouces Voir aussi pour TWO Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The Basics
• The extremely flat frequency response of the YSM1p Series 2 creates a wide aural
• Selectable High and Low frequency optimization allow subtle adjustments to the
• Sophisticated onboard Limiting includes a selectable Clip limiter, over-voltage limit-
• Actively crossed-over biamplification provides precise control over each
• Thermal amplifier protection assures reliable operation if the YSM1p Series
• The balanced/unbalanced "combi" input jack is capable of accepting either a
• The YSM1p Series 2 is electro-magnetically shielded to allow close proximity to

Input Connection

The input, located on the bottom part of the chassis, accepts line-level signal only (not
speaker level). It is recommended to use balanced, shielded cables with ¼ inch (T.R.S.)
or XLR connectors (unbalanced ¼ inch jacks can be used). Each YSM1p Series 2
should be connected to a single line-level source; e.g., the Right or Left line output from
a mixer or preamp. If you want to use multiple YSM1p Series 2s, they can be intercon-
nected using "Y" adaptors.
Input Trim Control
The Input Trim control allows you to adjust the sensitivity of the input circuit. Control
range is –6 dB to + 9 dB. Adjust accordingly until the desired sound level is achieved (a
normal setting would be 0 dB). If clipping is indicated (see Clip LED), reduce the Input
Trim level. If more control is needed, adjust your line level from the source.
Hi Frequency Reflection
Optimization DIP Switches
Walls, ceilings and furnishings reflect high
frequencies, this affects the listening environ-
ment. For most room acoustics set the lower
two DIP switches to the "Normal Room" [B]
configuration (settings are shown on the
back-panel. Otherwise select one of the other
two settings to reach the desired response
within the environment.
Low Frequency Efficiency Factor
DIP Switches
Due to the long wavelengths of low frequencies, a woofer's acoustic efficiency is
affected by its location within the room, relative to the walls. The diagrams shown on
the YSM1p Series 2 rear control panel depict three typical speaker/room placements
referred to as "Full, ½ and ¼ Space." Set the upper two DIP switches in accordance
with the cabinet's placement; Full Space, ½ Space or ¼ Space (corner placement). 1/2
Space [E] is considered default.
2
working area for the listener.
speaker/room response without compromising linearity.
ing which protects the tweeter (at all times) and an over-current limiter that con-
stantly guards the woofer ensuring clean reproduction.
driver's operation.
2 overheats during extenuating operating conditions. The circuit is also
designed to reset automatically.
¼-inch or XLR connector.
video monitors or magnetically sensitive devices.
YSM1
YSM1p Series 2 configuration options
P

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ysm1pYsm1p-iiYs1016

Table des Matières