Lucci fini 210255010 Instructions D'installation

Installation Instructions
SKU# 210255010 / SKU#210256010/ SKU#210257010/ SKU#210258010/ SKU#210259010
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before using the product. Please keep instructions for future reference.
Warranty
•
This fitting is covered by a 2 year warranty from the date of purchase. Please retain proof of purchase.
•
Warranty will be void if there is any damage due to improper usage or modification to the fitting.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void
warranty.
Installation requirements
•
If you are unfamiliar with wiring, use a qualified electrician.
•
All wiring and installation of the light fitting must adhere to local and national wiring rules.
•
Do not exceed the maximum wattage rating.
•
Select a suitable location for installation:
- This product is suitable for indoor use only.
•
Take care not to pull any electrical wires during unpacking as this may damage the connection.
•
Lay out all the components on a smooth surface and make sure there are no components missing before
assembling.
•
Check whether the fitting has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
•
Ensure power to the circuit you are working on has been switched OFF.
Installation directions
1. Remove all packaging material from the product.
2. Remove the fan bottom cover from the shaft of the fan.
3. Remove the shrinkable sleeve from light wires connector (B1).
4. Remove the lamp shade (D) from the light base (C) by turningit from anticlockwise.
5. Connect the light wire connectors (B1&B2) together.
6. Lift and align the base of the light (C) to the light base bracket (A), allow the bolt(G) go through the keyhole slot sand
(F), turn the light base anticlockwise. Align the screw holes between the light base (C) and the light base bracket (A)
and use the 3 mounting screws (E) to secure.
7. Reposition the lamp shade (D).
8. After the installation, switch on the fitting to test and enjoy your new lighting product.
1 | P a g e
For customer support, please contact:
Tel: +1 (949) 800 8488
CLIMATE LED LIGHT KIT
Rated Voltage 120V~ 60Hz
Email: support@beaconlighting.us
V 1 . 1 p u b l i c a t i o n o n 1 2 . 2 0 2 2
www.beaconlighting.us