Genesis GRT2103-40 Manuel D'utilisation page 12

HIgH SPEED DRILL BITS:
for fast drilling of holes in plastic, wood, and Softer metals.
FIBERgLASS CUT-OFF WHEELS AND EMERY CUT-OFF DISCS:
Cut-Off Discs and wheels of Various thicknesses are used for cutting and slotting all types of metals,
plastics, and very thin wood pieces.
The cut-off wheels must be mounted on the provided mandrel to be used. Loosen and remove the
screw in the top of the mandrel. Position the wheel between the two pink grommets. Replace and
tighten the screw to secure the wheel.
FELT POLISHINg WHEELS, BONNETS, AND POINTS:
use these (with polishing compound, if you like) to polish metals and plastics of various shapes and
sizes. use with Screw Mandrel.
FLAP WHEEL SANDER:
This Long-Lasting Attachment can do light grinding of metals, and handle all shapes and contours of
woods and plastics for Light to Heavy Sanding Operations.
MAINTENANCE
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from
various types of commercial solvents and may be damaged by their use. use clean cloths to remove
dirt, dust, oil, grease, etc.
WARNINg:
based products, penetrating oils, etc., come in contact with plastic parts.
Chemicals can damage, weaken or destroy plastic which may result in serious
personal injury.
electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject
to accelerated wear and possible premature failure because the fiberglass chips and grindings are
highly abrasive to bearings, brushes, commutators, etc. Consequently, we do not recommended using
this tool for extended work on these types of materials. However, if you do work with any of these
materials, it is extremely important to clean the tool using compressed air.
LUBRICATION
This tool is permanently lubricated at the factory and requires no additional lubrication.
Variable Speed Rotary Tool
Operator's Manual
Do not at any time let brake fluids, gasoline, petroleum-
GRT2103-40