Publicité
Les langues disponibles
Les langues disponibles
DIRECTIONS FOR USE
1. Before first use, connect controller wire to pad.
You should hear and feel it 'click' into place. Once
connected properly, the wire will not disconnect from
the pad.
2. Connect to USB-C power supply, output rated for
20W or higher, 12V 2A. We recommend the Goal
Zero - Venture 75.
3. For 12V barrel (5.5x2.1 coax) power supplies, remove
short USB-C adapter from end before connecting.
• Use optional Car Adapter to connect to vehicle or
larger batteries.
• Make sure seat or pad is unfolded, flat and not
covered by other insulated products (like sleeping bag
or blankets).
• Press and hold '+' button for 3 seconds until screen
powers on and reads 'IGNIK'
• Heat level will automatically show on screen with
previous Heat Level setting .
• Use +/- buttons to adjust the heat level. + for more
heat, - for less heat. Heat Levels range from 10 - 100 in
increments of 10 (10, 20, 30... up to 100).
M O R E H E A T . L E S S W A S T E .
1
2
3
Remove USB-C
Adapter
Publicité
