Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT: Carefully read this quick start instruction manual before
1 - Safety Instructions
Before any installation and use of the motor,
make sure that all appropriate safety rules are respected.
2 - Installing the motor
Air pressure should not exceed the maximum working pressure of the motor (6.2 bars)
Air flow must be sufficient for the motor : see table below
A Filtration, Regulation and Lubrication unit (FRL) must be installed upstream from the motor, with a 40 µm air filtration and an
adequate lubrication (see table below).
Temperature range : -30 and +150°C
3
- Installing the motor
a. Non reversible motor
1
2
b. Reversible motor
1
2
In case of a "lubrication free" air motor, a simple filter / pressure regulator shall be used.
installing and / or using a modec air motor
3
4
3
4
5
Distributor minimum flow
Lubrication (6.2 bars)
Minimum fitting
diameter
Minimum pipe diameter
(Max. length : 3m)
5
6
7
6
7
8
1000 Nl/min
4 drops/min
In
7 mm
Out
10 mm
In
9 mm
Out
13 mm
1.
Compressor
2.
Isolating valve
3.
Filter 40μm
4.
Pressure regulator
5.
Lubrication system
6.
3/2 valve (not required for motors
equipped with a handle Nxxx)
7.
Non reversible motor
8.
Air flow controller (option)
8
1.
Compressor
2.
Isolating valve
3.
Filter 40μm
4.
Pressure regulator
5.
Lubrication system
6.
5/3 valve (not required for motors
equipped with a handle Nxxx)
7.
Air flow controller (option)
8.
Reversible motor
0.28 in
0.39 in
0.35 in
0.51 in
Publicité
