modec 05 Serie Guide Rapide De Mise En Route page 5

IMPORTANT: Carefully read this quick start instruction manual before
1 - Safety Instructions
Before any installation and use of the motor,
Make sure that all appropriate safety rules are respected.
2 - Installing the motor
 Air pressure should not exceed the maximum working pressure of the motor (6.2 bars)
 Air flow must be sufficient for the motor : see table below
 A Filtration, Regulation and Lubrication unit (FRL) must be installed upstream from the motor, with a 40 µm air filtration and an
adequate lubrication (see table below).
 Temperature range : -30 and +150°C
3 - Installing the motor
a. Non reversible motor
1 2
b. Reversible motor
1 2
In case of a "lubrication free" air motor, a simple filter / pressure regulator shall be used.
installing and / or using a modec air motor
3 4
3 4 5
Distributor minimum flow
Lubrication (6.2 bars)
Minimum fitting diameter
Minimum pipe diameter
(max. length : 3m)
5 6 7
6 7 8
500 Nl/min
2 drops/min
In 5 mm
Out 5 mm
In 6 mm
Out 6 mm
1. Compressor
2. Isolating valve
3. Filter 40μm
4. Pressure regulator
5. Lubrication system
6. 3/2 valve (not required for motors
equipped with a handle NXX05)
7. Non reversible motor
8. Air flow controller (option)
8
1. Compressor
2. Isolating valve
Filter 50μm
3.
4. Pressure regulator
5. Lubrication system
6. 5/3 valve (not required for motors
equipped with a handle NXX05)
7. Air flow controller (option)
8. Reversible motor
0.20 in
0.20 in
0.24 in
0.24 in