Publicité
Les langues disponibles
Les langues disponibles
HOW TO INSTALL THE BATTERIES
Slide the cover open.
Make sure the direction is correct.
1.
Open the back cover and remove the insulating film from the batteries ;
2.
Insert the batteries into the slot, with the anode and cathode in the correct directions;
3.
Replace the back cover.
Warnings:
1.
The anode and cathode of the batteries must correspond to the "+" and "-" signs on the remote control;
2.
Do not use new batteries together with old batteries;
3.
If the batteries are not used for a long period of time, remove them.
4.
To avoid environmental pollution, remove used batteries and dispose of them safely and properly.
OPERATION
98
To operate the air conditioner, point the remote controller
at the signal receiver: the remote controller will operate
the air conditioner at a distance of up to 5 m when
pointing at the signal receiver of the air conditioner.
PROTECTION
The protection device trips and stops the application in the following cases.
Cooling
The indoor temperature of the room is above 43°C.
The indoor room temperature is below 15ºC.
Dehumidification
The temperature is below 15°C.
If the air conditioner is operated in cooling mode or dry mode with the door or the wind door open for a long time
when the relative humidity is above 80%, dew may drip from the outlet.
The protection device will operate in the following cases.
To restart the unit immediately after operation stops or to change the mode during operation, you must wait for
3 minutes. If the plug is pulled out, when restarting the unit, the unit will return to the original mode, the ON timer
and OFF timer must be set again.
SPECIAL REMINDER
There is a hidden condensation water recycling in this unit. The condensate water is kept partially
recycled between the condenser and the water plate.
When the water level rises to the upper level, the float switch and the water full indicator (E4) light up
to remind you to drain the water.
and the water full indicator (E4) light up to remind you to drain the water.
Please turn off the power supply, move the appliance to a suitable place, remove the drain plug,
drain the water completely.
After draining, replace the plug, or the appliance may leak and wet the room.
If the appliance is placed in a position that accepts drain water, you can also connect the drain hose
to the drain port to drain the water.
99
Publicité
