Rack Installation; Led Indicators - D-Link Media Converter Série Guide D'installation

Rack Installation

This media converter can also be installed into any of
the vacant slots of the specially designed DMC-1000
Media Converter Chassis.
Step 1: Unscrew and pull out the media converter
board from its original housing using the thumb
screw on the converter's front panel.
Step 2: Unscrew and remove the bay cover of any
of the empty slots in the chassis.
Step 3: Place the media converter board into the
vacant chassis slot and secure it using the thumb
screw on the converter's front panel.
2

LED Indicators

The LED indicators give you instant feedback on the
status of the converter.
LEDs Status
On
PWR
Off
On
LINK/ACT Blinking
Off
On
FDX/Col
Blinking
(10/100 Mbps
models only)
Off
100
On
(10/100 Mbps
Off
models only)
TECHNICAL SUPPORT
Indication
Powered on
Powered off
Link is active
Transmitting/receiving
data
Link is inactive
Using Full-Duplex mode
Indicates a collision of data
when using Half-Duplex
Device is using Half-
Duplex
Link has negotiated at 100
Mbps
Link has negotiated at 10
Mbps
dlink.com/support