Publicité
MAKING TERMINAL BLOCK CONNECTIONS
CAUTION: Use a multimeter to confirm wire polarity before making
!
connnections or damage to equipment may occur.
ATTENTION: Utiliser un multimètre pour confirmer la polarité des
!
fils avant d'effectuer la connexion ou des dommages à l'équipement
peut se produire.
1. Strip 1/4" of insulation from wire ends. (FIGURE A)
2. Determine correct polarity of positive + and negative -
wire ends.
3. Select appropriate color-coded terminal block:
D. Orange = 5V DC
E. Yellow = 12V DC
4. Insert bare wire ends into terminal block.
5. Tighten connections securely with screwdriver.
6. Insert terminal block into appropriate power bank.
INSTALLATION AND MOUNTING
A
C
+
Page 7
+
-
1/4"
FIGURE A
-
F
A
F
B
Publicité
