Publicité
EN
TECHNICAL DATA
Minimum dynamic pressure: 0.5 bar
Maximum operational pressure: 5 bar
Recommended operational pressure: 1-5 bar
It's recommended to use a pressure reducer in case of
static pressure superior than 5 bar inside the waterpipe.
Maximum hot water temperature: 80°C
INSTALLATION, MAINTENANCE AND PRELIMINARY CHECKING PROCEDURE
In order to get your device work correctly and fi ne in time, must ensure compliance with the
mode of installation and maintenance described in this booklet. Relying on a qualifi ed plumber.
Make sure that the system is free from all debris and impurities existing.
INSTALLATION
ATTENTION: The instructions are valid for the different models of spout and handle; the assem-
bly is always the same.
Fig. 1: Unscrew the screws from the carter and remove it. Unscrew the screws and remove the
fl at cover. Unscrew the thread protection cover. ATTENTION: do not throw the 8 screws, you
will need them.
Fig. 2 - 3: Position the cartridge lock and the diverter lock in the built-in body, being careful to
centre the rear plug. Fit the cartridge and diverter locks by tightening the four screws.
Fig. 4: Screw the fi tting onto the threaded hole.
Fig. 5: Insert the shower support on the fi tting, fi xing it with the grub screw.
After completing the installation of the cartridge lock and spout, turn on the stopcocks and
check that the mixer tap unit operates correctly. Keep the tap pressurised for a few minutes
checking eventual leaks.
Fig. 6: Insert the plate on the cartridge lock, on the diverter lock and on the shower support.
Fig. 7: Engage the fl ow control handle on the cartridge and secure it with the grub screw.
Fig. 8: Engage the temperature control handle on the cartridge rod, locking it with the grub
screw. Position the cover hole plug.
Fig. 9: Screw the threaded fi tting into the shower holder. Connect the hose to the threaded
connection and to the shower hand. Place the shower hand in its seat.
CLEANING
In order to obtain a correct cleanliness, exclusively wash them with soap and water, rewash and
dry them with a soft towel and deerskin. Avoid the usage of alcohol, solvents, solid or liquid
detergents which contain corrosive or acidic substances, abrasive sponges, swab with metallic
strings because they could irreversibly compromise the surfaces.
THE USAGE OF THIS KIND OF DETERGNETS DURING THE CLEANING OF THE MIXER EXCLUDE
IB RUBINETTERIE FROM ANY WARRANTY OBLIGATION.
Publicité
