RidgeMonkey MULTI LITE PLUS Mode D'emploi page 3

OPERATION
Press the power button to activate the Multi Lite Plus.
To change colour mode, double tap the power button: white
approximately two seconds in any mode.
Note: Red and Green colour options are available only in
POWER AND CHARGING
To recharge the internal lithium polymer battery: open the
rubber USB cover and use a micro USB cable to connect to
any CE/UL approved 5v power source. During charging the red
the Multi Lite Plus will automatically stop accepting charge and
the red LED charging indicator will constantly illuminate until
the device is disconnected from the power source. Full charge
from empty will take approximately 3-3.5 hours.
Note: Ensure that the Multi Lite Plus is completely dry before
attempting to charge the device. Do not attempt to charge the
Multi Lite Plus in temperatures above 35C or below 5C. Doing
so will void your warranty and may cause permanent damage
to the internal lithium cells of the device.
TECH SPEC
Water resistance rating: IP64
Spotlight max lumens: 145
Maximum power:
Charge port: Micro USB
Input: 5v/1A
Charging time: approximately 3-3.5 hours
Approximate battery life @ 15 Celcius:
150 hours
4 hours
Constant spotlight: 3 hours
depends on a number of factors, including (but not limited
to) ambient temperature, condition & age of battery, charging
habits etc. IP64 rating means that this device can withstand
water splashing from any direction, for example rain or boat
spray. It is not designed to be submerged for any period of
time.
CLEANING
Use a soft, damp cloth to wipe the surface and allow to
dry before storage. Do not use solvents as this may cause
unrepairable damage.
STORAGE
Before storing, ensure that the Multi Lite Plus is completely
dry. Store in a cool, dry place and ensure that the battery is
topped up to at least 50%. Long term storage of depleted
lithium batteries can cause unrepairable damage to the cells
which is not covered under guarantee.