Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT
DC(Direct Current) based system.
STEP 1:
Make the following Electrical Connec ons:
a.
Connect INPUT POSITIVE(+) conductor to RED WIRE posi on
of the terminal block or POSITIVE(+) conductor of LED driver.
b.
Connect INPUT NEGATIVE(-) conductor to BLACK WIRE
posi on of the terminal block or NEGATIVE(-) conductor of
LED driver.
c.
Connect INPUT DIM SIGNAL (WHITE WIRE) to Dim signal of
LED Driver.
STEP 2:
Make sure all excess input wires are pushed into pole, screws are
ghtened.
STEP 3:
Close cover by rmly pushing cover towards xture, making sure
that no wires are pinched and Sealing gasket are fully engaged.
STEP 4:
If the xture without a terminal block, please insulate all electrical
connec ons with wire nuts suitable for at least 90°C
This marking indicates that this product should not be disposed with other household wastes throughout the EU.
To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return your used device, please use
the return and collec on systems or contact the retailer where the product was purchased. They can take
this product for environmental safe recycling.
FIXTURE WIRING
TERMINAL BLOCK
POSITIVE(+)
+
NEGATIVE(-)
DIM Signal
(white)
-
DC BASED
POSITIVE(+) RED
NEGATIVE(-) BLACK
DIM Signal (White)
P.9/11
Publicité
