Hinkley MERRICK 60 Manuel D'instructions page 14

INSTALLING THE FAN WITHOUT THE LIGHT KIT (OPTIONAL)
Adapter Plate B
Screws
Fig. 1
Remove one of the three screws on the mounting hub
1
located on the fan motor. Loosen the other 2 screws. (Do
not remove) (Fig. 1)
Place the key holes on the adapter plate B over the 2
2
screws previously loosened, turn the adapter plate until it
locks in place at the narrow section of the key holes.
Secure by tightening the 2 screws previously loosened
and the one previously removed.
12 | hinkley.com
Mounting Hub
(bottom of motor)
Fig. 2
Raise the metal cover against adapter plate B and turn
1
clockwise until snug, DO NOT OVERTIGHTEN.
Metal Cover