Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
CAUTION!
Regular maintenance will extend the life of the treadmill
and prevent injury!
TROUBLESHOOTING
The display does not show any values: Check that the sensor and
console cables are properly attached and undamaged. If this does not
solve the problem, carefully bend the sensor.
The device squeaks: Check that all bolts and nuts are tight. If necessary.
No power: Check that all cables are connected.
Motor failure: Check that the motor needs to be replaced.
Power failure: Check that the sensor cable is properly connected.
Safety Key does not work properly: Check that the safety key is
properly attached.
ERROR CODES
Err(or E00): Security key is missing from the panel or is not properly
attached.
•
Solution: Attach the security key to the yellow part of the panel.
E2: Control board is broken.
Solution: Replace the control board.
•
E4: Control board is broken.
•
Solution: Replace the control board.
E5: Short circuit in the control board or the motor is blocked.
•
Solution: Check if the motor is blocked. If this does not solve the
problem, please contact the supplier.
E6: Motor broken or motor not connected properly
•
Solution: Check if the motor is broken or incorrectly connected,
reconnect the wiring if necessary. If this does not solve the
problem, please contact the supplier.
E7: Wires from control board to panel damaged or not connected
properly.
Solution: Check if the wires are connected properly and not
•
damaged, if necessary connect the wires again. If this does not
solve the problem, please contact the supplier.
E8: Appliance is receiving too much electrical power or is overloaded.
•
Solution: Check that the load capacity is not exceeded.
Reconnect power and restart the treadmill. If this does not
correct the problem, contact the supplier.
CONTROL PANEL (FIG. A)
•
SPORTS MODE Press "START" to start treadmill.
•
COUNTDOWN MODE Press "M" to select TIME, DISTANCE or
CALORIES mode.
•
PRESET PROGRAM (P01-P12) Select program and press "+" or
"-" to set time.
Functies
•
TIME Displays the training time (0:00 ~ 99:59 minutes). You can
also set a training time (5:00 ~ 99:00 minutes). The time is
adjusted from the set value to 0, after which the treadmill
slowly stops. END" is shown in the display. The treadmill will go
into standby mode after 5 seconds.
•
STEP Displays steps (0 ~ 9999 steps). The display will toggle
from exercise time to number of steps taken. Press "M" to
select a single display mode.
DISTANCE Displays the distance. A distance can also be set.
•
The distance is accumulated from 0 to the set value and then
the treadmill stops slowly. END" is displayed. The treadmill will
go into standby mode after 5 seconds.
CALORIES Displays the calories burned. You can also set a goal.
•
The goal is counted down from the set value to 0 and the
treadmill stops slowly. END" is displayed. The treadmill will go
into standby mode after 5 seconds. The display will change
from calories burned to distance. Press "M" to select a single
display
mode.
07
Publicité
