Logic Instrument FIELDBOOK I1 Mode D'emploi page 7

GETTING STARTED
1. Switch on the Backup battery
For security reasons the backup battery is switched OFF during transit in order to
completely cut off power to the device. Please note that this step is not necessary to run the
Fieldbook on battery power but it is necessary to support hot swapping the main battery.
a) Open the I/O compartment
cover on the left side of
the Fieldbook
b) Set the switch to the „ON" position
c) Close the I/O compartment cover
2. Installing the Main Battery
WARNING: Only use the battery supplied with your Fieldbook or batteries suggested
by Logic Instrument. Using wrong batteries might harm the device or cause fire and
explosions.
a. Place the Fieldbook display side down on a plane and clean surface
b. Make sure that the
locking switch (upper
lock) is unlocked
If the battery locks are not completely set to
3. Turn on the Fieldbook
a) Press and hold the power button until the power LED lights up.
c. Align the battery
tabs with the slots on
the chassis
the Fieldbook will not run on battery power.
7
d. Press down the
battery until the
release switch clicks
into place
When reliability matters
e. Slide the locking
switch to the right
(LOCK)