EUROM DryBest 20 Manuel D'utilisation page 21

Display
The display normally shows the air humidity in the space.
If you set a required humidity, it will show the set air humidity for a few seconds.
If you set a switching on or off time with the timer, the display will show the set
number of hour for a few seconds.
If the air humidity is less than 35%, it will show "LO" (low)
If the air humidity is higher than 95%, it will show "HI" (high)
Initial operation
1. Insert the plug into an appropriate socket, in accordance with the specifications
on the type plate. Only connect the appliance to an earthed socket!
2. Press the ON/OFF button (A); you will hear the compressor and the fan start up
(the "comp" lamp c.q. the "power" lamp will now light up continuously). The
appliance will start working. The display will show the air humidity in the space.
By pressing the ON/OFF button again, you will switch the appliance off.
3. Using the "Higher" and "Lower" buttons (D&E), you can now set the required air
humidity between 30% and 90% (at intervals of 5%). The display will show the
set air humidity for a few seconds, afterwards the current air humidity will be
shown. Once the required level has been reached (± 2%), the compressor will
stop, the fan continues to run. The dehumidifier thus keeps the air in the room
moving and is therefore able to feel the humidity and to catch on again in time.
If the air humidity rises once more to more than 3% above the set value, the
appliance will start again. The compressor has a time lag of at least 3 minutes
protection time between stopping and starting.
If you set the air humidity with the "Lower" button to "Co", the appliance will
operate continuously.
4. Using the Timer button (B), you can set starting and stopping times for the
appliance. To do this, press the Timer button (B); lamp (2) will light up. If you
do this while the appliance is not in operation (but with the plug in the socket),
you will set the starting time; if you do this while the appliance is in operation,
you will set the stopping time. The number of hours set will appear on the
display. Each time you press the "Timer" button, an hour will be added (setting
from 1 to 24 hours). You can cancel the timer setting by setting the time to 0 (0
comes after 24). The time setting is "forgotten" when you switch the appliance
off manually, but is kept in memory if the appliance stops because the reservoir
is full or during the thawing process.
5. DryBest 20: Pressing the fan speed button changes the fan speed from high to
low and back. The lamp indicates the operational capacity.
6. DryBest 20: Pressing the clean dryer button will continually dehumidify the
appliance at a high fan speed.
7. Make sure that you then remove the plug from the socket after use.
21