Tassili Supra VICTOR 3021086 Guide D'installation page 8

CLEANING AND MAINTENANCE
To clean the toilet, use warm, soapy water. Rinse thoroughly with fresh water and dry with a soft cloth. Avoid detergents, disinfectants,
or cleaning products in aerosol cans. NEVER use abrasive powders, scouring powders or pads on the toilet seat. Some bathroom
chemicals and cosmetics may damage the seat's finish.
WARNING: Do not use in-tank cleaners. Products containing chlorine (calcium hypochlorite) can seriously damage fittings in the
tank. This can cause leakage and property damage.
PROBLEM POSSIBLE CAUSES
a. Water supply valve is closed.
Does not flush
b. Supply line blocked.
c. Poorly installed push-button.
a. Bowl water level too low.
Slow or weak
b. Supply valve partly closed.
flush
c. Partially clogged trapway.
d. Supply pressure too low.
a. Poor supply line connection.
Toilet leaks
b. Poor bowl to tank/floor connection.
a. Push-button rod is too long.
Toilet does not
b. Flush valve seat and/or seal worn or deformed.
shut off
VICTOR
3021086
RESPECTE LA NORME B651-04
DE L'ASSOCIATION CANADIENNE
DE NORMALISATION.
TS2206
MEETS THE B651-04
STANDARD OF THE CANADIAN
STANDARDS ASSOCIATION.
TROUBLESHOOTING GUIDE
SOLUTIONS
a. Open valve and allow water to fill tank.
b. Shut off water supply, disconnect supply line, and inspect all
gaskets and washers. Reassemble.
c. Readjust the push-button rod length as necessary.
a. Check that the refill tube is connected to the water fill control
regulator and inserted into the refill float without being kinked
or damaged.
b. Open the supply valve completely. Be sure that the proper
supply tube is used.
c. Remove any obstruction. Consult a plumber if necessary.
d. Normal supply pressure must be at least 20 psi.
a. Review step 6 of the installation procedure.
b. Review steps 4 to 6 of the installation procedure.
a. Readjust the rod as needed.
b. Replace seal/flush valve assembly as needed.