Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTIONS
1. Mount the shaft (10) on the base seat (1), then place the gaskets (12) on each side, then the wheel
(2)(the wheel's "spokes" face out). Place another gasket (12) on the outside of the wheel and secure with
a split pin (13). Bend the legs of the fork pins to prevent them from falling out.
2. Install casters (3) on the bottom seat (1) using eight sets of M6 fasteners (11).
3. Install the rear panel (4) on the base (1) using two M6 fasteners (11).
4. Install the left drawer channel plate (16) and left support leg (7) on the bottom seat (1) using a 2M6
fastener (11). The drawer channel plate is located inside the base and the support leg is located outside t
he base. Do not tighten fasteners at this stage.
5. Install the right drawer channel plate (16) and the right supporting leg (7) on the bottom seat (1) through
the 2M6 fastener (11). The drawer channel plate is located inside the base and the support leg is located
outside the base. Do not tighten fasteners at this stage.
6. Install the chassis (5) on the rear panel (4), left and right drawer channel plates, and left and right support
legs using six M6 fasteners (11). The shelf is inside the slot board of the drawer. Do not tighten fasteners at
this stage.
7. Use 8 sets of M6 fasteners (11) to install the welder bracket (6) on the rear panel (4) and left and right
support legs. Secure all fasteners installed in Step 4 to Step 7.
8. Slot drawer (15) into drawer. Do it gently, don't tug at the drawer. Lockable drawers must be on top.
9. Fix the hook (9) on the left and right supporting legs with four sets of M6 fasteners (11).
Publicité
