Publicité
Les langues disponibles
Les langues disponibles
installing your dryer
CONNECTING THE INLET HOSE
Insert new rubber washer (supplied) into each end of the
inlet hoses. Firmly seat the washers in the couplings.
Method1
The dryer must be connected to the cold water faucet using the
new inlet hoses. Do not use old hoses.
1. If space permits, attach the brass female end of the "Y"
connector to the cold water faucet.
2. Turn the cold water faucet off.
3. Attach the straight end of long hose to "Y' connector.
4. Using pliers, tighten the coupling with an additional two-
thirds turn.
Do not overtighten, as it may damage the coupling.
5. Attach angled end of long hoses to fill the valve at the
bottom of the dryer's rear frame. Screw on coupling by hand
until it is seated on fill valve connector.
6. Using pliers, tighten the coupling with an additional two-
thirds turn.
Do not overtighten, as it may damage the coupling.
7. Check that the water faucets are on.
8. Check for leaks around "Y" connector, faucets and hoses.
Method2
The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old
hoses.
1. Fasten the female screw of the Y connector to the cold
water inlet of the washer by hand.
2. Fasten the connected part firmly by turning it 1~2 times
with a pair of pliers. (Avoid using excessive force.)
3. Connect one end of the cold water supply hose of the
washer to one of the male screws of the Y connector and
connect the other end of the hose to the water faucet.
4. Connect one end of the long hose of the Steam Dryer to
one of the male screws of the Y connector and connect the
other end to the water inlet at the bottom of the back of the
dryer.
5. Fasten each of the connected parts firmly by turning it 1~2
times with a pair of pliers (avoid using excessive force) and
then open the water faucet to check if there is no water
leakage.
14_ Installing your dryer
DV448AEW-02555B-05_EN.indd 14
2009-02-17 ¿ÀÈÄ 4:25:26
Publicité
