Danze DF024211 Instructions D'installation page 4

5
2. Line up the mounting template (Z) over the
horizontal line and mark the location of the
mounting bracket holes with a pencil.
3. Drill 1/4" holes for anchors (C) using 1/4" drill
bit.
4. Remove screws (C1) and black washers (C2)
from anchors (C). Tap anchors (C) into the holes
until they are flush against the surface. Use a
hammer if necessary.
5. Align mounting brackets (D) with holes on
wall. Insert screws (C1), black washers (C2) first;
tighten screws (C1) using Phillips screwdriver
until the anchors (C) expand inside wall.
6. Hang the mirror (A) and use the Phillips screw-
driver to adjust screws at the top of mirror (A) to
level if needed.
Please refer to Homeowner Care Manual for care and maintenance information.
6