Table of Contents
1. Fan / Remote is not working
2. Fan is noisy
3. Fan Wobbles
4. Light is not working
Please refer to the instruction sheet for detailed directions and descriptions of installation
steps and requirements.
1. FAN / REMOTE IS NOT WORKING
Ensure the remote is within the 20 foot range of the receiver
To reset the remote control: 1) Turn off power to fan using the wall switch or circuit breaker. 2) Remove ba eries from remote.
3) Wait 10 seconds. 4) Replace ba eries and turn power on
Check ba eries to insure they are good and oriented correctly
Check to make sure the frequency switches (DIP Switches) from the remote to the receiver are set to the same frequency
Check the main and branch circuit fuses or breakers
If using a Variable Speed Wall Switch, ensure it is specifically designed for use with a ceiling fan.
Check the line wire connec
2. THE FAN IS NOISY
Make sure all motor housing screws are
Make sure the screws that a
Make sure the wire nut connectors are not ra
Allow 24-hour break in period. Most noises associated with the new fan may disappear during th
If using a ceiling light kit, make sure the glassware is secur
Make sure there is a short distance/gap from the ceiling to the top of the canopy. The canopy should not touch the ceiling!
Make sure your ceiling box is secure and that the rubber isolator pads are used between the moun
3. THE FAN WOBBLES
Verify all blades and blade bracket screws are secure (most fan wobble problems are caused by loose parts). Once fan is properly
installed, run the ceiling fan for 10 minutes to let the fan self-adjust.
If wobble occurs a er running the fan for 10 minutes, verify blade level using the following process:
a) select a point on the ceiling above the p of one of the blades. Then select the fan blade and measure from the center of the
selected blade to point on the ceiling. Rotate the fan un
same point from the ceiling for every blade. Measurements should be within 1/8 inch.
to order a complimentary Blade Balancing Kit
4. LIGHT IS NOT WORKING
Check Bulb to make sure it is installed correctly
Remove non-working bulb and replace with a bulb that is known to be a good working bulb
To reset the remote control: 1) Turn off power to fan using the wall switch or circuit breaker. 2) Remove ba eries from
remote. 3) Wait 10 seconds. 4) Replace ba
TROUBLESHOOTING GUIDE
ns to the fan and the switch wire conn
tened
an blade to motor ar
against each other or the interior wall of the switch housing
and turn power on
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
e switch housing per the instru
Support@parrotuncle.com
t
htly
e next blade is
oned and repeat the measurement using the
F6240110V-CA
me
acket and outlet box
Customer Service Support@parr
ns
otuncle.com