YORKVILLE NX Flyware NXF35U Mode D'emploi page 2

All manuals and user guides at all-guides.com
Attaching the NXF35U
Bracket to NX Enclosures
Mount the NXF35U bracket onto the NX enclosure prior
to flying or mounting.
Step 1 – Installing the Bottom
Enclosure Adapter Plate
First, remove the rear rubber foot (figure 1), be sure
to re-insert the bolt to plug hole to prevent air-leak.
Remove the enclosure's bottom four stand adapter
bolts (figure 1). Do not remove the Stand Adapter.
Position the bottom Enclosure Adapter Plate on the
Stand adapter (as shown in figure 2). Use the four
¼-20 x ¾-inch bolts (with ¼-inch lockwashers) pro-
vided to mount the bottom Enclosure Adapter Plate
to the enclosure (on top of the Stand Adapter).
Note: a / -inch wrench will be needed.
7
16
Step 2 – Installing the Top
Enclosure Adapter Plate
On the top of the NX enclosure, position the top
Enclosure Adapter Plate (as shown in figure 3), and
use two of the bolts (provided with the kit) to mount the
plate on the enclosure.
Step 3 – Mounting the Enclosure to
the Steel U-Bracket
With the NX enclosure on its side, mount the Steel
U-Bracket as shown in the figure 4a and 4b. Align the
holes on the bracket with the corresponding holes on
the NX enclosure as shown (the top uses a single bolt
to mount the Steel U-Bracket and the bottom uses two).
Top
(FIGURE 4a)
Step 4 – Assembly complete
Tighten all bolts mounting the bracket to the NX enclo-
sure appropriately before flying.
Bottom
(FIGURE 4b)
Canada
Voice: (905) 837-8481
Fax: (905) 837-8746
w w w . y o r k v i l l e . c o m
Yorkville Sound
550 Granite Court
Pickering, Ontario
L1W-3Y8 CANADA

Stand Adapter Screws
(FIGURE 1)
Use 7 / -inch wrench
16
Bottom Plate Placement
(FIGURE 2)
Top Plate Placement
(FIGURE 3)
U.S.A.
Voice: (716) 297-2920
Fax: (716) 297-3689
Yorkville Sound Inc.
4625 Witmer Industrial Estate
Niagara Falls, New York
14305 USA