ELTRACE DOMOCLICK DHB-100 Mode D'emploi page 7

DOMOCLICK™ Fast Connector
T derivation set with electrical
DOMOCLICK™ T derivation set with electrical supply for the junction between three heating tapes and the
supply cable
Box and cover in polyamid, Ligature, Incorporated electrical connection
including cablegland PG 16 for DHB 104, Stirrups for wall mounting CE
Composition
1. T derivation with electrical supply
2. Three terminations
3. Three heat-resistant ligatures
4. Three stirrups for wall mounting
5. Self-adhesive labels "electric supply" and "terminal"
Easy
Eltrace heating tapes are supplied and connected between themselves with a minimum of manipulations. Only a knife
in needed to strip the band ends. The different clicks are made up of only three parts.
Sure
The mounting stages are visible and easily controllable. The upper and lower blades guarantee a sure contact.
Fast
It takes only a few minutes to assemble the Click, for it involves only four stages:
1. Insert the band into the cover and the metal cone
2. Strip the band end.
3. Insert the heating tape into the Click.
4. Push the lever and shut the cover.
Installation prescriptions
The installation of bands, connections to DOMOCLICK™ connectors to connection boxes will be carried
out according to the rules of the trade. Before going ahead with work on electric tracers, care will be taken to isolate
them from the mains. The DOMOCLICK™ connection and junction techniques are approved if used together with self
-adjusting Eltrace heating tapes. Eltrace guarantees correct working only in relation with the mentions heating tapes.
Through the direct mounting onto the pipe, DOMOCLICK™ uses less heating tape. As a general rule, DOMO-
CLICK™ is fixed to the pipe with the supplied ligatures. DOMOCLICK™ can also be fixed to the wall with supplied
stirrups. The supply cable is to bedirectly connected into the DOMOCLICK™. Any exterior supply, junction or deriva-
tion box is thus avoided. In anti-frost installations for gutters, DOMOCLICK™ must not be installed in a gutter or on
the roof, but in a sheltered position under the roof or eave. DOMOCLICK™ can be installed directly on pipes with a
service temperature of less than 70°C. Short periods at 80°C are admitted. Important : for admitted temperatures
of heating tapes, refer to the technical data
DOMOCLICK™ incorporated into pipe insulation. All supply points, junctions and terminals must remain acces-
sible. Electrical supply points and terminals must be indicated with the supplied self-adhesive labels.
Product Qualification
CE
ELTRACE - 12, rue des frères Lumière - F-77290 - MITRY MORY - France - Tel: +33 (0)1 64 62 04 40 - Fax: +33 (0) 1 64 62 00 54 - www.eltrace.com - info@eltrace.com
In order to improve the quality of our products ELTRACE reserve the right to make changes—20140617 Domoclick Fast Connector
DOMOCLICK™- DHB-104