Publicité
Les langues disponibles
Les langues disponibles
Starting
- Press on the on/off switch (n°3 on picture) to start the unit. The electronic
thermostat turns on.
- Wait for the unit to be at the right temperature (stop of the compressor).
- Press on the light switch (n°1 on picture) to start the light.
Temperature setting
The electronic thermostat is preset in factory. It can be adjusted if necessary.
To modify the temperature, refer to the
thermostat.
Regulation of defrost
The defrost is an important operation for ventilated refrigerating displays like CD
1200 I / CD 1200 B.
A homogeneous temperature is ensured thanks to the air circulation through the
evaporator. This evaporator has a negative temperature when the compressor is
working. In this way, its blades "trap" the humidity as frost, and the air of the
chamber dries. If there is too much frost, the air cannot circulate through the
evaporator and the internal temperature rises.
In order to avoid this phenomenon, the defrost programmed in the factory stops the
compressor 10min every 2 hours.
These values can be adjusted by your technician. It depends on the type of products
presented in the refrigerating display, on the use and the environment.
To stop the display during the night and the closing days enables a total defrost.
Stopping the appliance
Set each switch (n°1 and 3 on picture) on 0: the appliance is no longer
functioning.
Disconnect the power supply cable.
Clean the appliance. (See 6. Cleaning)
d) Breakdown / repair:
In case of breakdown or of damaged part, please call your after-sales service and
confide any technical operation to a qualified person.
When you contact the after-sales service of your distributor or your store, provide
him with the complete reference of your device (commercial name, type and serial
number). This information appears on the visible descriptive plate behind the device.
technical documentation of the
12
Publicité
