Max MX700 Manuel D'instructions page 4

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
GENERAL
1. Microphone volume control
2. Microphone echo volume control
3. Treble control
4. Bass control
5. Subwoofer volume control
6. Master volume control
7. Microphone input for Jack 6.3 mm
8. Line input for Jack 6.3 mm
9. AUX in-/output RCA connector
10. Speaker output satellite 1
11. Speaker output satellite 2
BT CONNECTION
Press on button mode till you see "BT". Then use your mobile or computer to search a BT device. When you find the "MX700",
then connect. There's no code needed.
4