iCES IFT-1050 Mode D'emploi page 2

All manuals and user guides at all-guides.com
Dear Customer,
Please read these operating instructions through carefully before connecting your device to the mains, in
order to avoid damage due to incorrect use.Please pay particular attention to the safety information. If
you pass the device on to a third party, these operating instructions must also be handed over.
STRUCTURE
1. SWITCH PANEL 5. TIMER
2. REAR COVER 6. SPEED SWITCH
3. FRONT COVER 7. OSCILLATION SWITCH
4. BASE
ASSEMBLY
1. Pass the cord through the hole in the base.
2. Insert the front case into the base and turn the butterfly screw clockwise.
3. Pass Cord though pillar of the base.
4. Remove the protruded section by lifting the rib and then pulling the front grill.
5. Remove the knob screw by turning it counter clockwise.
6. Remove the protruded section by pulling the rear grill.
OSCILLATION CONTROL
1. Oscillation is operated by activating the oscillation switch.
2. When the oscillation switch is pushed down, the oscillation is activated. When the oscillation
switch is pulled up, the oscillation is turned off.
3. When the switch is set at OFF position, oscillation is not possible.
CAUTION
1. Read the instructions on the manual carefully before using for the first time.
2. Before connecting to the power source, check if the voltage specified on the appliance