ALPATEC RI 810 T Mode D'emploi page 11

All manuals and user guides at all-guides.com
notice RI 810 T: notice RI 810 T
Your unit is designed to remove dirt and other atmospheric impurities by drawing in air through the air
filter. On no account should this be blocked in any way as this will impair the efficiency of the machine.
Pushing the unit up against a wall or operating in very close proximity to long window drapes will
impair the air flow and efficiency.
REAR AIR FILTER
This is easily accessible by removing the rear screen and removing the filter.
In a smoky or dusty environment this filter becomes grey in colour after one or two months.
Disconnect machine from mains supply. Gently wash the filter in mild soapy water, dry and replace. Be
sure to refit the rear screen securely. No special tools are required for this.
WATER TANK
If the unit is in regular service it is not necessary to clean the water tank regularly. However, in hard
water areas, deposits will build up and it is recommended that cleaning with mild soapy water once
every six months should be sufficient.
1. Disconnect the appliance from mains supply.
2. Remove complete rear panel by carefully removing the service screws. Do not use to pull the rear
frame out as the mains lead is still connected internally via a quick fit connector.
3. When the connector can be seen and reached, disconnect and remove panel completely.
4. Remove any deposits or dirt from within the tank with a mild soapy detergent and cloth.
5. Flush with clean water and drain via the drain plug.
6. Reverse procedure and make sure rear panel is correctly located before replacing and tightening
service screws.
INTERNAL HUMIDITY SCREEN
Use exactly the same procedure as for cleaning the water tank.
1. With the rear panel separated, carefully remove the humidity screen from its rollers.
2. Soak the screen in warm mild soapy water until clean.
3. Replace on rollers.
4. Reverse the removal procedure.
5. It is recommended to proceed every 6-12 months.
OUTSIDE CABINET
Use warm mild soapy water and cloth. Do not use abrasive products.
IMPORTANT :
The control panel must not be in contact with water or any other liquids.
5/11/07 18:03 Page 11
CLEANING
CLEANING
11