Publicité
Les langues disponibles
Les langues disponibles
�
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause hannful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This transmitter
must not
or operating in conjunction
be co-located
party
responsible for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class 8 digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause hannful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or m0f8 of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement: The product complies with the FCC/IC AF Exposure for Low Power Consumer Wireless Power Transfer. RF
exposure limit set
for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure
forth
that compliance was demonstrated at 10cm and greater separation from the user body or set the device to lower output power if such function
ls avallable.
This device complies with Industry Canada's license-exempt RSSs. Operation is subject to the following
(1) This device may
cause interference;
not
(2) This device must
any interlerence, including interference that may cause undesired operation of
accept
The
"IC:
ff
before the certificatiorv'registration number only signifies that
term
applicable Industry Canada technical specifications.
the
For complete warranty details, please visit us at
www.scosche.com or call (800) 363-4490
FLYTUNES
Power On - Press and Hold MFB for 3 seconds.
Power Off - Press and Hold MFB for 3 seconds.
Pairing Mode - Press and Hold MFB for 5 seconds.
Dual Pairing Mode - Double Tap MFB.
Play/Pause - Short Press MFB.
LED STATUS INDICATORS
Power On - Blinking Blue
Pairing Mode - Blinking Red/Blue
Dual Pairing Mode - Blinking Red/Solid Blue
Charging - Solid Red
Fully Charged - Solid Blue
FCC STATEMENT
any other antenna or transmitter. Changes or modifications not expressly approved by the
with
used in accordance with the instructions, may cause harmful interference to radio
and
receiver.
and
IC STATEMENT
and
Industry Ganada technical specifications were met. This product meets
the
FUNCTIONS
conditions:
two
device.
the
Publicité
